Configuration Guide Configuring WLAN Log
3. Number of associated online STAs
4. Number of online STAs which have passed Web authentication
5. Number of online STAs which have passed 802.1x authentication
6. Intensity of the co-channel interference signal
7. Number of received error frames
8. Packet retransmission times
The general information on the STA includes:
1. IP address
2. Signal strength
3. Access rate
4. Associated AP, radio and SSID
STA's spatial information
The STA's spatial information mainly includes the statistics of data frame and management frame of the STA, as well as
the statistics of each type of rate, as detailed below:
1. Number of data frames successfully transmitted (from the AP to the STA)/total traffic
2. Number of unresponsive data frames/total traffic
3. Number of management frames/total traffic
4. Statistics of each type of frames with access rate (The access rate is divided into 8 grades for statistics)
5. Statistics of each type of frame with MIMO rate (The MIMO rate is divided into 8 grades for statistics)
The spatial information is mainly used to check whether the STA is in low-speed state, whether the proportion of the case in
which no ACK frame is transmitted is too high, and whether too many management frames are transmitted and received, so
as to further analyze and locate the network problems caused by low speed node, management frame attack, and poor
condition. The STA's spatial information varies in real time, and the current collection frequency is once every five minutes.
The information is saved only on the AP due to large data volume.
AP Behavior Type
The AP behavior type includes going online, going offline and CAPWAP connection failure.
Features
To Next Page
Loading...
