Configuration Guide Configuring LLDP
If no IPv6 address is found, the loopback address 127.0.0.1 is used as the management address.
Canceling the Management Address
no lldp management-address-tlv
Interface configuration mode
A management address is advertised through LLDP packets by default. The management address is the
IPv4 address of the minimum VLAN supported by the port. If no IPv4 address is configured for the VLAN,
LLDP keeps searching for the qualified IP address.
If no IPv4 address is found, LLDP searches for the IPv6 address of the minimum VLAN supported by the
port.
If no IPv6 address is found, the loopback address 127.0.0.1 is used as the management address.
Configuration Example
Configuring the Management Address to Be Advertised
Set the management address to 192.168.1.1 on an interface.
Ruijie(config)#interface gigabitethernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)#lldp management-address-tlv 192.168.1.1
Display configuration on the interface.
Ruijie(config-if-GigabitEthernet 0/1)#show lldp local-information interface GigabitEthernet 0/1
Lldp local-information of port [GigabitEthernet 0/1]
Port ID type : Interface name
Port id : GigabitEthernet 0/1
Port description : GigabitEthernet 0/1
Management address subtype : ipv4
Management address : 192.168.1.1
Interface numbering subtype : ifIndex
Interface number : 1
Object identifier :
To Next Page
Loading...
