Ruijie RG-WLAN Series

Configuration Guide Configuring PPPoE Client
 Intranet hosts cannot access the Internet because NAT configuration is incorrect.
 Intranet hosts cannot access the Internet because route configuration is incorrect.
6.5 Monitoring
6.5.1.1 Clearing Various Information
If you run the clear pppoe tunnel command while the device is operating, packet forwarding will be interrupted
due to tunnel clearance.
Function
Command
Clears statistics about the DDR dialer
interface.
clear dialer [ interface-type interface-number ]
Clears the tunnel.
clear pppoe tunnel
6.5.1.2 Displaying the Running Status
Function
Command
Displays information about the DDR
dialer.
show dialer [ interface type number ] [ maps ] [ pools ]
Displays PPPoE status information.
show pppoe { ref | session | tunnel }
6.5.1.3 Displaying Debugging Information
System resources are occupied when debugging information is output. Therefore, disable the debugging switch
immediately after use.
Command
Function
debug dialer { pkt |
mlp|callback|event }
Enables the DDR debugging switch.
debug ppp [ authentication | error |
event | negotiation | packet ]
Enables the PPP negotiation debugging switch.
debug pppoe [ datas | errors |
events | packets ]
Enables the PPPoE negotiation debugging switch.