Ruijie RG-WLAN Series - Page 43

Configuration Guide Configuring Band Select
Verification
 Run the show band-select configuration command to display parameters of the Band Select function.
 Run the show running-config command to check whether the Band Select function is enabled.
 After a period of running, run the show band-select statistics command to check the statistics on the AC.
 Check whether the Band Select function controls the active scanning process by capturing packets.
Configuration
Example
N/A
Common Errors
 The parameters are improper.
 The Band Select function is not enabled.
 One of the two RF interfaces of a dual-band AP is disabled.
2.5 Monitoring
Displaying
Description
Command
Displays the configuration of the
Band Select function.
show band-select configuration
Displays the statistics of the Band
Select function.
show band-select statistics