Ruijie RG-WLAN Series - Page 42

Configuration Guide Configuring Band Select
Command
band-select age-out { dual-band value | suppression value }
Parameter
Description
dual-band value: Specifies the aging time of dual-band STA information, ranging from 20 to 120
seconds.
suppression value: Specifies the aging time of inhibition STA information, ranging from 10 to 60
seconds.
Defaults
The aging time of dual-band STA information is 60 seconds and the aging time of inhibition STA
information is 20 seconds.
Command
Mode
Global configuration mode
Usage Guide
It is recommended that the aging time of dual-band STA information be set to twice or three times that of
inhibition STA information.
 Configuring the Probe Count of an Inhibition STA
 (Optional) If a single-band 2.4 GHz STA cannot discover a WLAN for a long time, this parameter should be set to a
smaller value.
 If there is no special requirement, enable this function on a fat AP.
 The greater the probe count of an STA, the stronger inhibition the Band Select function performs on an inhibition
STA, and the more difficult the inhibition STA discovers a WLAN. On the other hand, the smaller the probe count of
an STA, the weaker inhibition the Band Select function performs on an inhibition STA, and the easier the inhibition
STA discovers a WLAN.
Command
band-select probe-count value
Parameter
Description
value: Specifies the probe count of an inhibition STA, ranging from 1 to 10.
Defaults
The default value is 2.
Command
Mode
Global configuration mode
Usage Guide
N/A
 Configuring the Scanning Cycle Threshold of an STA
 (Optional) If a single-band 2.4 GHz STA cannot discover a WLAN for a long time, this parameter should be set to a
smaller value. If it is uncertain, use the Defaults.
 If there is no special requirement, enable this function on a fat AP.
 The greater the scanning cycle threshold of an STA, the more slowly the probe count of the STA increases, and the
more difficult the STA discovers a WLAN. On the other hand, the smaller the scanning cycle threshold of the STA,
the more quickly the probe count of the STA increases, and the easier the STA discovers a WLAN.
Command
band-select scan-cycle value
Parameter
Description
value: Specifies the scanning cycle threshold of an STA, ranging from 1 to 1000 milliseconds.
Defaults
The default value is 200 milliseconds.
Command
Mode
Global configuration mode
Usage Guide
N/A