Configuration Guide Configuring FSS
4 Configuring FSS
4.1 Overview
By enabling frequency spectrum scanning (FSS), an AP can operate in the FSS mode and actually act as a wireless
frequency spectrum sensor which is responsible for collecting and analyzing non-802.11 wireless signal frequency
spectrum and sends the results of frequency spectrum analysis to the frequency spectrum analysis server. After
processing, the frequency spectrum analysis server shows the results of frequency spectrum analysis to users in intuitive
forms such as graphic, list and alarm.
FSS is used with Ruijie's SNC software to achieve frequency spectrum analysis.
4.2 Applications
Networking with the SNC Software to
Achieve Frequency Spectrum
Analysis
FSS is networked with Ruijie's SNC software to achieve frequency spectrum
analysis.
4.2.1 Networking with the SNC Software to Achieve Frequency Spectrum Analysis
Scenario
Ruijie's SNC software achieves frequency spectrum analysis. The SNC software is networked with Ruijie's wireless AP
system, as shown in Figure 4-1:
There are non-802.11 wireless interference devices such as microwave ovens and cordless phones in the RF
environment.
Figure 4-1
A. The SNC software is installed on the SNC server.
B. The AC and AP constitute the wireless FIT AP system.
To Next Page
Loading...
