Configuration Guide Configuring FSS
Deployment
Enable frequency spectrum analysis on the AP.
Establish a connection between the SNC software and the AP.
4.3 Features
Basic Concepts
Video Bridge Interference
During operation, a video bridge may generate wireless signals that interfere with WLAN transmission. The FSS of an AP
can recognize and send the video bridge interferences to the SNC software for analysis.
Microwave Oven Interference
During operation, a microwave oven may generate microwave leakage that interferes with WLAN transmission. The FSS
of an AP can recognize and send the microwave interferences to the SNC software for analysis.
Cordless Phone Interference
During operation, a cordless phone may generate wireless signals that interfere with WLAN transmission. The FSS of an
AP can recognize and send the cordless phone interferences to the SNC software for analysis.
Bluetooth Interference
During operation, a Bluetooth device may generate wireless signals that interfere with WLAN transmission. The FSS of an
AP can recognize and send the Bluetooth device interferences to the SNC software for analysis.
Continuous Wave
During operation, a continuous wave may generate wireless signals that interfere with WLAN transmission. The FSS of an
AP can recognize and send the continuous wave interferences to the SNC software for analysis.
Scanning Precision
The scanning precision indicates the serial number of the scanned characteristic waveform which is then determined as a
specific interference source. Normally, a higher scanning precision leads to a higher probability of correct determination.
Scanning Duration
When performing frequency spectrum scanning, an AP cannot provide normal wireless services. The system regularly
switches between wireless services and frequency spectrum scanning to give consideration to both. A longer scanning
duration leads to a higher probability of locating interferences.
Overview
To Next Page
Loading...
