Ruijie RG-WLAN Series - Page 475

Configuration Guide Configuring DHCPv6
Verification
 Run the show ipv6 dhcp interface command to display whether an interface of the host obtains
configuration parameters.
Ruijie#show ipv6 dhcp interface GigabitEthernet 0/2
GigabitEthernet 0/2 is in client mode
DNS server: 2001::1
Rapid-Commit: disable
Common Errors
 The DHCPv6 client address request is enabled on non-layer-3 interfaces.
 The DHCPv6 address request is enabled on interfaces enabled with the DHCPv6 relay or DHCPV6 server.
 The DHCPv6 client prefix request is enabled on non-layer-3 interfaces.
 The DHCPv6 prefix request is enabled on interfaces enabled with the DHCPv6 relay or DHCPV6 server.
5.5 Monitoring
Clearing
Running the clear commands may lose vital information and thus interrupt services.
Description
Command
Clears DHCPv6 bindings.
clear ipv6 dhcp binding [ ipv6-address ]
Clears DHCPv6 server statistics.
clear ipv6 dhcp server statistics
Clears conflicted addresses on the
DHCPv6 server.
clear ipv6 dhcp conflict { ipv6-address | * }
Clears the statistics on sent and
received packets after the DHCPv6
relay is enabled on the current
device.
clear ipv6 dhcp relay statistics
Restarts the DHCPv6 client.
clear ipv6 dhcp client interface-type interface-number
Displaying
Description
Command
Displays the DUID of a device.
show ipv6 dhcp
Displays address bindings on the
DHCPv6 server.
show ipv6 dhcp binding [ ipv6-address ]
Displays DHCPv6 interface.
show ipv6 dhcp interface [ interface-name ]
Displays DHCPv6 pool.
show ipv6 dhcp pool [ poolname ]
Displays conflicted DHCPv6
addresses.
show ipv6 dhcp conflict