Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring Network Communication Test Tools
Ruijie# ping ipv6 2001::5 length 1500 ntimes 100 data ffff source 2001::9 timeout 3
Sending 100, 1500-byte ICMP Echoes to 2000::1, timeout is 3 seconds:
< press Ctrl+C to break >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!
Success rate is 100 percent (100/100), round-trip min/avg/max = 2/2/3 ms
Detailed ping command:
Ruijie#ping 2001::5 length 1500 ntimes 10 data ffff source 2001::9 timeout 3
Sending 10, 1500-byte ICMP Echoes to 2001::5, timeout is 3 seconds:
< press Ctrl+C to break >
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Reply from 2001::5: bytes=1500 time=1ms
Success rate is 100 percent (10/10), round-trip min/avg/max = 1/1/1 ms.
Verification
Send one hundred 1500-byte packets to the specified IPv6 address, and the response information (if any)
will be displayed in the specified time (3s by default). Finally the statistics is output.
7.4.2 Traceroute Test
Configuration Effect
After conducting a traceroute test on a network device, you can learn about the routing topology between the network device
and the destination host, and the gateways through which packets are sent from the network device to the destination host.
Notes
The network device must be configured with an IP address.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English