Configuration Guide Configuring FSS
Notes
Enable FSS in global configuration mode.
Configuration Steps
Enabling FSS
(Mandatory) Run the spectral enable command to enable or disable FSS in the AP configuration mode.
Enable FSS for the target AP that is FSS-capable in the AP configuration mode.
Global configuration mode
Verification
Run the show running-config command to verify that the frequency spectrum scanning precision is configured on the
target AP.
Configuration
Example
Enabling FSS
Enable FSS for a specified AP.
Ruijie# configure terminal
Ruijie(config)# spectral enable
Ruijie(config)# end
Run the show running-config command to verify that FSS is enabled on the target AP.
Ruijie# show running config
spectral enable
Common Errors
This command is used in the all AP configuration mode.
4.4.2 Configuring the Interference Recognition Precision for Frequency Spectrum
Scanning
Configuration Effect