Ruijie RG-WLAN Series

Configuration Guide Configuring Web Authentication
1.4.38 Upgrade Compatibility
Configuration Effect
 Some configuration commands are optimized in the 11.X series software and the command formats are changed. For
details, see the subsequent description.
 The 10.X series software supports smooth upgrade without function loss. However, some commands are displayed in
new formats after upgrade.
 When you run the commands in earlier formats in the no form in the 11.X series software, a message is displayed,
indicating the no form is not supported. You need to perform the no operation in new command formats.
Configuration Steps
 It is recommended that you run commands in new formats.
Verification
 Check that function loss does not occur when the 10.X series software is upgraded to the 11.X series software, and
commands are displayed and stored in new formats.
 The commands in new formats have the same functions as the commands in earlier formats.
Related Commands
 Configuring the Resource Address of the Portal Server in Ruijie First-Generation Web Authentication
Command
http redirect homepge url
Parameter
Description
url: Indicates the resource address of the ePortal server in Ruijie First-Generation Web Authentication.
Command
Mode
Global configuration mode
Usage Guide
In the 11.X version, the command is converted into an eportalv1 template, and the url command in template
configuration mode is executed to configure and display the IP address of the portal server. For details, see
section 1.4.1"Configuring Ruijie First-Generation Web Authentication."
 Configuring the Portal Server
Command
portal-server [eportal1 | eportalv2]
Parameter
Description
eportav1: Indicates the information of the portal server used in Ruijie First-Generation Web Authentication.
eportav2: Indicates the information of the portal server used in Ruijie Second-Generation Web
Authentication.
Command
Mode
Global configuration mode
Usage Guide
In the 11.X version, the command is converted into an eportalv1 or eportalv2 template, and relevant
information is filled in. The main parameters of the portal server include the IP address and URL of the
server. The original command will be replaced by the ip command and url command in the template.