Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring RSNA
Verification
Run the show running-config | begin wlansec wlan_id command to check whether the configuration takes
effect.
AP
Ruijie#show running-config | begin wlansec 1
wlansec 1
security static-wep-key encryption 40 ascii 1 12345
security static-wep-key authentication share-key
!
Common Errors
 The configured key length is inconsistent with the specified key length.
 Static WEP is configured for multiple WLANs.
 The link authentication mode is configured before static WEP is enabled.
1.4.2 Configuring WPA Authentication
Configuration Effect
 Enable WPA authentication for a WLAN.
 Specify the access authentication mode and encryption mode in WPA authentication.
Notes
 When WPA authentication is used, the encryption mode and access authentication mode must also be configured.
 If the access authentication mode is set to PSK, a PSK key must be configured.
 In the security mode of a WLAN, WPA authentication cannot be configured with WEP authentication.
Configuration Steps
 Configuring WPA Authentication
 Mandatory.
 Enable WPA authentication in WLAN security configuration mode on the AP.
Command
security wpa { enable | disable }
Parameter
Description
enable: Enables WPA authentication.
disable: Disables WPA authentication.
Defaults
WPA authentication is disabled by default.
Command
Mode
WLAN security configuration mode
Usage Guide
The encryption mode and access authentication mode can be configured in WPA authentication only after
WPA authentication is enabled; otherwise, the configuration does not take effect.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English