9
Connecting the Balance to Line Voltage
The balance is energized by a power supply. Make sure that the voltage rating
printed o n this unit is identical to your local line voltage.
lf the voltage specified on the label or the plug design of the power supply does
not match the rating or Standard you use, please contact your Sartorius Office or
dealer.
The power supply is suitable for installation as stationary equipment. To use a
main feeder cable from the ceiling or to mount a CEE plug, you will have to make
arrangements inside your facilities for installation of such cable equipment by a
certified electrician.
Important Note
Use only original Sartorius Power Supplies identified by the Sartorius label. Use of
power supplies from other manufacturers, even if these units have an approval
identification marking from a national testing laboratory, requires the consent of
an authorized Sartorius service technician.
To operate your balance using an external rechargeable battery, pack, see "Ac-
cessories" in "Part II: Product Data Sheet.".
Detailed information on additional options for powering the balance is available
in our Service Information bulletin, no. 15/88 (fore example, using local! extra-
low voltage).
Plug the cord of the power supply into the AC jack on the balance, Then insert the
plug of the power supply in a wall outlet.
To Next Page
Loading...
Need help?
General