10
Safety Precautions
The power supply rated to Class 2 can be plugged into a wall outlet without tak-
ing any additional safety precautions. The pole of the Output voltage is connected
to the balance housing, which can be grounded for Operation.
The interface (see "Interfacing Devices" on page 28 in addition) is also electrically
connected to the balance housing (ground).
Information on Radio-Frequency Interference:
Warning!
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause inter-
ference to radio communications.
It has been tested and found to comply with the limits for a class A computing de-
vice pursuant to Subpart J of Part 15 of FCC rules, which are designed to provide
reasonable. protection against such interference, when operated in a commercial
environment Operation of this equipment in a residential area is likely to cause in-
terference, in which case the user at this own expense will be required .to take
whatever measures may be required to correct the interference.
Connecting Electronic Devices (Peripherals)
Make sure to unplug the balance from the power
supply before you connect or disconnect a
peripheral device (printer or PC) to or from the
interface port. Safety Precautions
To Next Page
Loading...
Need help?
General