3
Contents
Page
Warranty 4
Storage and Shipping Conditions 5
Transporting the Balance 5
Equipment Supplied 6
Installation instructions 7
Ambient Conditions 7
Getting Started 8
Adjusting the Exterior Draft 8
Adjusting the Swivel-Mounted Display Unit 8
Connecting the Balance to Line Voltage 9
Safety Precautions 10
Information on Radio-Frequency Interference 10
Connecting Electronic Devices (Peripherals) 10
Information on Weighing
Electro statically Charged Samples 11
Levelling the Balance Listing the Level Indicator 11
How to Operate the Balance 12
Turning the Display On and Off (Standby Mode) 13
Self-Test 13
Important Note for Automatic
Operation with a Robot 13
Opening and Closing the Draft Shield Door 14
Weighing 16
Taring 16
Weighing Range Structure 17
Weighing in the IQ-Mode™ 18
(Load-Dependent Readability)
Mass Unit Conversion by Toggling 19
Page
Calibration and Linearization 20
Fully Automatic Calibration 21
Internal Calibration 22
External! Calibration 23
Calibration Test 24
Internal Linearization 25
For additional functions if you want to
do more than "just weigh," see
"Part III: Balance Operating Menu" and
"Part IV! Application Programs"
Data Interface 26
Interfacing Devices with the Balance 27
Below- Balance Weighing 28
How to Fasten the Antitheft
Locking Device 28
Troubleshooting Guide 29
Care and Maintenance 30
Cleaning the Balance Housing
and the Draft Shield 30
Cleaning the Weighing Chamber 30
Safety Inspection 31
Safety Certificate 32
To Next Page
Loading...
Need help?
General