30
Care and Maintenance
Before cleaning the balance, unplug the power supply from the wall outlet.
Cleaning the Balance Housing and the Draft Shield
Please do not use any aggressive cleaning agents (solvents or similar agents]. In-
stead, use a piece of lint-free cloth which has been wet with a mild detergent.
Clean the semi cylindrical elements of the draft shield with a commercially avail-
able glass cleaning agent.
Make sure that no liquid enters the balance housing.
After cleaning, wipe down the balance with a soft, dry piece of cloth.
Cleaning the Weighing Chamber
Keep the draft shield base plate from becoming too dirty:
Carefully remove spilled powder from the weighing chamber by using a small
vacuum cleaner (such as a small car vacuum cleaner with a mini-hose attached).
Afterwards, remove the weighing pan (7] and the shield disk (8) from the weigh-
ing chamber.
Vacuum out the remaining powder from the weighing chamber using the same
equipment described above.
Do not clean the weighing chamber by blowing off powder from the parts!
To remove liquid spills, use blotting paper.
To Next Page
Loading...
