16
Weighing
Place your sample on the weighing pan (7) to determine the weight, and dose the
draft shield door (for example, by pressing the
key (22). Do not read off the
weight indicated in the display (18) until the weight unit (in this case “g” or a dif-
ferent unit selected - see "Part III: Balance Operating Menu"} appears as the sta-
bility symbol.
Taring
lf you wish to use a Container or if the weight display does not indicate
0.00000 g or 0.0000 g (depending on the particular balance model you are us-
ing, or on the display mode selected), zero the display before You weigh.
To do so, press the tare control
(24).
During taring, you can have the fully automatic draft shield function either on or
off. To shorten work procedures; and make them easier, you should have this fully
automatic function o n active Status. In this case, after you press the tare control,
the draft shield door will dose, the balance will be tared, and the draft shield door
will re-open.
For more information on turning this function on or off by menu code, refer to
"Part III: Balance Operating Menu."
To Next Page
Loading...
Need help?
General