10
Control Commands with Upper-Case Letters or Special Characters
ESC P CR LF
Print
ESC Q CR LF
Acoustic signal
ESC S CR LF
Self-test
ESC T CR LF
Tare
ESC Z CR LF
Internal calibration
ESC = CR LF
Internal linearization
The commands "P" through "=' do not affect the code settings of the balance operating menu. The command S causes the
processor to reinitialize (turns the balance off and back on again).
The balance will operate according to the commands available up until the processor is reinitialized. Once the balance has
been turned on, the processor will always recognize the codes entered by the user in the balance operating menu.
ESC O CR LF
Block keypad
ESC R CR LF
Release keypad
Adaptation to Ambient Conditions
ESC K CR LF
Very stable
ESC L CR LF
Stable
ESC M CR LF
Unstable
ESC N CR LF
Very unstable
To Next Page
Loading...
