21
Data Output at Defined Intervals
You can reduce the volume of data in the "auto print" mode by defining the interval at which data will be Output automatically.
This auto print interval is based on the number of times the display is updated.
Auto print interval Code
1 display update * 6 3 1
2 display updates 6 3 2
5 display updates 6 3 3
10 display updates 6 3 4
20 display updates 6 3 5
50 display updates 6 3 6
100 display updates 6 3 7
Automatic Taring after Data Output
This convenient setting lets you checkweigh a series of samples or products without having to unload the balance after each
weighing Operation.
This means less work for you:
– the sample remains on the pan after the weight readout has been printed or transferred to an on-line Computer
– the balance is tared automatically after the weight readout has been printed or transferred to an on-line Computer
– you simply load the next sample or part
Automatic taring after data output Code
Data output without automatic taring * 6 4 1
Data output with automatic taring 6 4 2
Data ID Codes
To help you identify weights, piece counts, percentages, etc., a code letter is printed or displayed in front of these values.
For example, an "N" printed or displayed before a weight value identifies it as a net weight. You will find the data ID codes of
a particular application program listed in the corresponding description. This ID code increases the data Output format from
16 to 22 characters for each weight readout.
ID code for data output Code
Without * 7 2 1
With 7 2 2
* = Factory setting
To Next Page
Loading...
Need help?
General