Section 2: Command Codes
Page 2-12 SATO Programming Reference
Special Notes 1. Use of this command will set the Vertical/Horizontal Offset setting of
the printer configuration until a new Base Reference Point command
is issued or the setting is changed from the operator panel.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your cur-
rent Horizontal and Vertical Print Position commands.
Example: Let us say the current base reference point is H=1, V=1 and
you wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point command,
see Section 1. Print Area.
5. The "Se" print engines can print as close as 2 mm to the inside edge
of the label.
6. The printers will not “wrap” (i.e. if any part of a character or image
extends beyond the last print dot position, it will disappear and not be
visible on any part of the label).
7. See Table 1 in Section 1. Programming Concepts for values of Hmax
and Vmax.
To Next Page
Loading...
Need help?
General
