Section 2: Command Codes
SATO Programming Reference PN 9001096 Rev. A Page 2-13
Characters,Custom-Designed
Command Structure Store Command: <ESC>Tabcc
Recall Command: <ESC>Kab90cc
a = 1 16x16 matrix
2 24x24 matrix
b=
Specifies the character encoding method for the data
stream
H Hexadecimal characters
B Binary characters
cc =
Memory location to store/recall the character. Valid
memory locations are 21 to 52 (counting in Hex) or “!”
or “R” in Binary.
(data) = Data to describe the character
Example: <ESC>T1H3F
<ESC>K1H903F
See Appendix C for a more detailed explanation
Placement: The Store command is typically sent in its own data
stream to the printer, between the Start/Stop
commands. The Recall command is sent in a
secondary data stream to print the character, and
follows any necessary position or size commands.
Default: None
Command Function To allow for the creation, storage, and printing of custom characters, such
as special fonts or logos. Up to 50 individual characters may be stored in
the custom character volatile memory.
Printer Input See Appendix C for a detailed explanation.
<ESC>A <ESC>T1H3F0100038007C00FE01FF03FF87FFCFFFE
07C007C007C007C007C007C007C007C0
<ESC>Z
<ESC>A <ESC>H150<ESC>V100<ESC>L0505<ESC>K1H903F
<ESC>H350<ESC>V100<ESC>L1010<E SC>K1H903F <ESC>Q1
<ESC>Z
To Next Page
Loading...
Need help?
General
