SATO E series User Manual

Section 2: Command Codes
Page 2-26 SATO Programming Reference
Cut Last
Command Structure <ESC>~B
Example: <ESC>~B
Placement: Separate data stream sent to the printer
Default: None
Command Function To control the cutting of labels when using a SATO cutter unit with the
printer. This command allows the cutting of a printed multi-part tag or label
that is left in the printer after a job is cut.
Input to Printer <ESC>A
<ESC>~B
<ESC>Z
Printer Output This command will feed the last printed label to the cut position, cut the
label and then back feed to the head position in preparation for printing
the next job.
Special Notes 1. You must have the optional printer Cutter to use this function. Contact
your SATO representative for more information.

SATO E series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Max. Print Speed	6 ips (inches per second)
Max. Print Width	4.09 inches (104 mm)
Interfaces	USB, Ethernet
Media Type	Labels, Tags, Ticket
Ribbon Length	Up to 984 ft (300 m)
Power Supply	AC 100-240V, 50/60 Hz
Print Resolution	203 dpi