SATO E series User Manual

Section 6: Configuration Commands
Page 6-2 SATO Programming Reference
Custom Protocol Command Codes
Download
COMMAND STRUCTURE <ESC>LD,a,b,c,d,e,f,g,h,i,jj
a
b
c
d
e
f
g
=
=
=
=
=
=
=
Replacement character for STX
Replacement character for ETX
Replacement character for ESC
Replacement character for ENQ
Replacement character for CAN
Replacement character for NUL
Replacement character for OFFLINE
h = Auto-Online. Printer powers up in the On Line mode.
0 Yes
1 No
i = Zero Slash. Places a slash through the “0” character.
0 Yes
1 No
jj =
Hexadecimal code for Eurocharacter
Example: <ESC>LD,{,},%,#,&,*,~,0,0,D5
Placement: Immediately following the <ESC>A Start command and
in an independent data stream.
Default: Standard Protocol command Codes
COMMAND FUNCTION Allows the user to defines custom Protocol Command codes.
PRINTER INPUT <ESC>A
<ESC>LD,{,},%,#,&,*,~,0,0,D5
<ESC>Z
PRINTER OUTPUT A Protocol Command code status label will be printed as a result of the a
successful download of a custom set of Protocol Command codes.

SATO E series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Max. Print Speed	6 ips (inches per second)
Max. Print Width	4.09 inches (104 mm)
Interfaces	USB, Ethernet
Media Type	Labels, Tags, Ticket
Ribbon Length	Up to 984 ft (300 m)
Power Supply	AC 100-240V, 50/60 Hz
Print Resolution	203 dpi