Section 4: Expanded Memory Commands
Page 4-6 SATO Programming Reference
Format/Field Store
Command Structure <ESC>YS,aa<ESC>/N,bb,cc{.......}
aa
bb
cc
{.....}
=
=
=
=
Format number to be stored (01-99)
Field number to be stored (01-99)
Length of field to be stored (01-99)
Command stream describing the field to be stored.
Example: <ESC>YS,01<ESC>/N,01,05
Placement: Immediately after <ESC>CC Memory Area Select command.
Default: None
Command Function To store a format field description in the memory card.
Printer Input ESC>A
<ESC>CC1
<ESC>YS,02<ESC>/N,01,13<ESC>V0100<ESC>H0100<ESC>XB1
<ESC>/N,02,13<ESC>V0200<ESC>H0200<ESC>XB1
<ESC>Z
Printer Output There is no printer output as a result of this command. See <ESC>YR
Format/Field Recall command.
Special Notes 1. This command requires the Expanded Memory option. See your SATO
representative for details.
2. Each job should be sent individually. If more than one job is sent in a
data stream, only the first one will be accepted and the remainder
ignored.
3. The following commands cannot be stored in a format:
<ESC>CS Print Speed <ESC>C Repeat Label
<ESC>NULL Cut Label <ESC>Q Print Quantity
<ESC>/D Recall Field <ESC>EX Expanded Label Storage
<ESC>T Custom Characters <ESC>& Store Form Overlay
<ESC>@ Off Line <ESC>#E Print Darkness
<ESC>BJ TrueType Fonts <ESC>ID Store Job ID
<ESC>G Store Custom Graphics <ESC>* Clear Memory & Buffer
<ESC>BT Variable Ratio Bar Codes <ESC>PI Store PCX Graphics
<ESC>0 Partial Edit
To Next Page
Loading...
Need help?
General
