Section 6: Configuration Commands
SATO Programming Reference Page 6-7
Pitch Offset
COMMAND STRUCTURE <ESC>POabcc
a = 3 Continuous
b = + Positive Offset
- Negative Offset
cc = 00 to 99, Offset value in dots
Example: See above
Placement: Separate data stream sent to printer
Default: Default value set by <ESC>PG command
COMMAND FUNCTION To set the pitch offset used for a job.
INPUT TO PRINTER <ESC>A
<ESC>PO3+20
<ESC>Z
PRINTER OUTPUT Blank label
SPECIAL NOTES 1. When power is cycled, the value set by this command is lost and
replaced by the default value stored in the EEPROM.
2. To change the value stored in the EEPROM, use the <ESC>PC
Printer Setting command or use the Printer Setting Utility program
contained on the CDROM shipped with the printer.
To Next Page
Loading...
