SATO E series - Legacy Commands

Appendix A: Command Code Quick Reference
Page A-16 SATO Programming Reference
LEGACY COMMANDS
These commands are provided for legacy applications that use command streams
created for older SATO printers. It is not recommended that these commands be used
for new applications.
AX Expanded Print Length. This command sets the printer to the Expanded print
length (14 inches). <ESC>EX0 is the recommended replacement.
N Rotate, Moving Base Reference Point. Sets the original base reference point
and returns printing to normal orientation. <ESC>% is the recommended
replacement.
R Rotate, Moving Base Reference Point. Rotates the printing of all subsequent
images by 90 degrees counterclockwise each time it is used. Also moves the
base reference point. <ESC>% is the recommended replacement.