Section 2: Command Codes
SATO Programming Reference PN 9001096 Rev. A Page 2-67
Start/Stop Label
Command Structure Start Command: <ESC>A
Stop Command: <ESC>Z
Example: See above
Placement: <ESC>A must precede data <ESC>Z must follow
data
Default: None
Command Function For all print jobs, the Start command must precede the data, and the Stop
command must follow. The print job will not run properly if these are not in
place.
Input to Printer <ESC>A
<ESC>H0001<ESC>V0100<ESC>WB1SATO
<ESC>H0130<ESC>V0200<ESC>B103150*M-8485S*
<ESC>H0170<ESC>V0360<ESC>L0202<ESC>S*M-8485S*
<ESC>Q1<ESC>Z
Printer Output There is no output for these commands they are not accompanied by
other label printing commands. However, these commands must precede
and follow each print job sent to the printer.
To Next Page
Loading...
