Section 2: Command Codes
Page 2-42 SATO Programming Reference
Job Name
Command Structure <ESC>WKnnn. . . n
nn..n = Job Name assigned, up to 16 ASCII characters
Example: <ESC>WKSATO
Placement: Immediately following the <ESC>A in the job data stream.
Default: None
Command Function This command is to identify a particular job using a descriptive name
Printer Input <ESC>A
<ESC>WKSATO
. . . Job . . .
<ESC>Z
Printer Output There is no printer output as a result of this command. The information is
returned to the host upon receipt of a Bi-Com status request.
Special Notes 1. Works only in Bi-Com 4 mode. The Job Name must be stored before
Bi-Com status mode can be used.
2. If more than one Job Name is sent in a single job, i.e.
<ESC>A
<ESC>WKSATO
. . . . . . . . . .
<ESC>WKSATO AMERICA
. . . . . . . . .
the last name transmitted will be used.
To Next Page
Loading...
