Appendix D: Custom Protocol Command Codes
Page D-2 SATO Programming Reference
DOWNLOAD COMMAND STRUCTURE
The command for downloading a new set of Protocol Command Codes takes the form
of “<ESC>LD,a,b,c,d,e,f,g,h,i,j j”. The parameters specified for “a” through “i” can be
transmitted in either ASCII characters or hex notation, allowing a complete 128
character (except for the “,”) set to be used for selecting the custom code.
RESET
If the custom Protocol Command codes are incorrect or if the printer does not respond
to commands using the custom set, the Alternate Protocol Control Codes can be
restored by the following procedure:
1. Turn the printer off.
2. Place DIP switch DS2-7 in the ON position.
3. Turn power on while simultaneously pressing the FEED and LINE switches.
4. 4 When the message “ALT PROTOCOL DEFAULT COMPLETED” appears on the
display, turn the printer off.
5. When the printer is powered up again, the Alternate Protocol Command Code set
will be active. All previous custom settings will be lost.
PARAMETER STANDARD SETTING ALTERNATE SETTING
(DEFAULT)
aSTX {
bETX }
c ESC
^
dENQ @
eCAN !
gOFF-LINE ]
h (Auto ONLINE) No 0 = Yes
1 = No
i (Zero Slash) No 0 = Yes
1 = No
jj (Eurocharacter) D5 User Defined
To Next Page
Loading...
Need help?
General
