SATO E series User Manual

Section 2: Command Codes
Page 2-14 SATO Programming Reference
Printer Output
Special Notes 1. When printing the custom character using the Recall command, the
character is affected by the following commands: Character Expansion
Character Pitch Line Feed Rotate, Fixed Base Reference Point
2. The characters are stored in volatile memory and must be reloaded if
the printer power is lost.
3. Do not use ASCII <CR> or <LF> characters (carriage return or line
feed) as line delimiters within the graphic data or the actual image will
not be printed as specified.

SATO E series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Max. Print Speed	6 ips (inches per second)
Max. Print Width	4.09 inches (104 mm)
Interfaces	USB, Ethernet
Media Type	Labels, Tags, Ticket
Ribbon Length	Up to 984 ft (300 m)
Power Supply	AC 100-240V, 50/60 Hz
Print Resolution	203 dpi