Section 2: Command Codes
SATO Programming Reference PN 9001096 Rev. A Page 2-23
Special Notes 1. Use the Print Position commands (V and H) to locate the new area for
the duplicate image.
2. Position of the new target area must not be inside the original image.
3. If you use the Rotate command, V, H, X and Y axis will be reversed.
4. If the reference area of the target image exceeds the print area, it will
not be printed.
5. See Table 1 in Section 1.Programming Concepts for values of Hmax
and Vmax.
To Next Page
Loading...
