Section 2: Command Codes
SATO Programming Reference PN 9001096 Rev. A Page 2-33
Printer Output
Special Notes 1. Auto-smoothing (when enabled) is only effective if the character expan-
sion rate is at least (3) times in each direction.
2. Characters may be enlarged through the use of the <ESC>L Character
Expansion command.
3. Character spacing may be altered through the use of the <ESC>A Char-
acter Pitch command.
4. A font must be defined for each field to be printed. There is no default
font.
5. The proportionally spaced fonts XU, XS, XM, XL and XB can be printed
with fixed spacing using the <ESC>PS Proportional Space command.
To Next Page
Loading...
