Section 2: Command Codes
SATO Programming Reference PN 9001096 Rev. A Page 2-53
SPECIAL NOTES 1. EX0 is effective until AR is sent to reset the printer to its standard
print length, or until the printer is re-powered.
2. See Section 1, Table 1 for values of Vmax.
3. When this command is used with the <ESC>& Store Form Overlay
command the Form length cannot exceed the maximum specified.
4. If a job contains elements out of the memory range, it is ignored.
5. If the Forms Overlay command <ESC>& is used with Expanded
Memory to expand the print area, the Form Overlay length is still lim-
ited to the maximum.
To Next Page
Loading...
