Section 2: Command Codes
SATO Programming Reference PN 9001096 Rev. A Page 2-55
SPECIAL NOTES 1. To expand the print length to the maximum limit, the <ESC>EX0
Expanded Print Length command must be used.
2. See Table 1 in Section 1. Programming Concepts for values of Hmax
and Vmax.
3. If any part of an image is placed past the maximum number of dots,
that part of the image will be lost.
4. If any part of an image is placed past maximum allowable dots across
the label, that part of the image will be lost.
5. If you attempt to print where there is no paper, you may damage the
print head.
6. For these commands, the leading zeroes do not have to be entered.
The command “V1” is equivalent to “V0001”.
To Next Page
Loading...
