SATO S84 ex - Page 108

4 Operation and Configuration
106
S84-ex/S86-ex Operator Manual
LEGACY STATUS FOR PORT 9100
Set the compatibility in the response data configuration of Status with old
models such as M8485Se, M8490Se, M8459Se, M8460Se, M8465Se and
S84.
• ENABLE: Use the data configuration same as old model.
• DISABLE: Use a data configuration different from the old model.
The difference in the response data is as follows:
Status3
Status4
Status5
Note
This setting does not have to be changed when using the S84-ex/S86-ex
printer driver.
ENABLE DISABLE (Default)
ENQ (05H)
response
prefix: 4 bytes
00H 00H 00H 0BH
prefix: 0 byte
ENABLE DISABLE (Default)
CAN (18H)
response
1 byte
06H
5 bytes
00H 00H 00H 01H 06H
DLE (10H)
response
1 byte
06H
5 bytes
00H 00H 00H 01H 06H
DC1 (11H)
response
1 byte
06H
5 bytes
00H 00H 00H 01H 06H
ENQ (05H)
response
prefix: 8 bytes
00H 00H 00H 20H 00H
00H 00H 1CH
prefix: 4 bytes
00H 00H 00H 1CH
ENABLE DISABLE (Default)
ENQ (05H)
response
prefix: 4 bytes
00H 00H 00H 16H
prefix: 0 byte
/(*$&<67$786
)253257
(1$%/(',6$%/(