SATO S84 ex - Download Mode

4 Operation and Configuration
196
S84-ex/S86-ex Operator Manual
4.2.19 Download Mode
This download feature allows the operator to download data (firmware, font/logo, TrueType font,
configuration) from the host computer through the interface, SD card or USB memory and write in the
Flash ROM memory. When downloading is complete, the LCD screen will return to the original screen
after three seconds. If an error occurs, an error message will show and the reason will be identified.
The flowchart shows the sequence of the setting screens for the download mode. The table describes
each setting screen in detail.
CAUTION
Be sure to perform a virus check on the USB memory or SD card before connecting it to the product. SATO
Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB
memory or SD card.
Download Font, Logo, TTF
Press the button
+
Power On
Program
download
Indication of
new entry
Indication of
overwriting
Deletion
Screen messages are shown in English regardless of the
setting value on the SELECT LANGUAGE screen.
Select INTERFACE
+ button
After 3 beeps, the product returns to the DOWNLOAD READY screen.
Download
completed?
Yes
No
When downloading
the configurations
of the product, the
verifying step is
skipped.
Select SD CARD or USB MEMORY + button
Waiting to receive data from the interface selected on the
DATA PORT screen of the interface mode.
* Continue to show
while receiving Font
or Logo information.
3 short beeps
when the
download is
completed.
button
button