2 Installing the Product
35
S84-ex/S86-ex Operator Manual
2.5
Connecting the Power Cord
WARNING
• Do not touch the power switch, connect or disconnect the power cord while your hands are wet. Doing so
could cause an electric shock.
• Always connect the ground wire to a ground terminal. Electric shock could occur if you do not.
Note
• The attached power cord is designed exclusively for this product.
• Do not use the attached power cord with other devices.
1 Connect the power cord to the AC input
terminal at the rear of the product.
Take note of the orientation of the connector.
Secure the product with one hand, and insert the
connector tightly.
2 Insert the power plug into an AC outlet.
Make sure that the AC voltage of your region is in
the range of AC 100-240 V, 50-60 Hz. If your
local voltage is not in the stated range, contact
your SATO reseller or technical support center.
*The shape of the power plug varies depending
on the region in which it was purchased.
Note
This product is also designed for IT power distribution
system with phase-to-phase voltage 230 V.
To Next Page
Loading...
