SATO S84 ex - Media Motion of the Product Operation

9 Appendix
347
S84-ex/S86-ex Operator Manual
9.7 Media Motion of the Product Operation
9.7.1 Feed Motion
When the pitch sensor is disabled, media will be fed while pressing the FEED button.
When the pitch sensor is enabled, one media will be fed according to the backfeed motion setting.
9.7.2 Paper End
The settings of PAPER END sensor and PAPER END DISTANCE for detection can be specified in the
advanced mode.
The distance setting option for detection is available only if the Gap sensor is selected for paper end
sensor.
I-mark Sensor Is Selected for Paper End Sensor
When the I-mark sensor level has changed to high for 15 mm (0.6”), it will be considered as the paper
end.
Gap Sensor Is Selected for Paper End Sensor
When the Gap sensor level has changed to low and falls within the scope of the set distance (15 mm ~
400mm (0.6” ~ 15.7”)), it will be considered as the paper end.
15 mm
Detection of paper end error
2.5 V
I-mark
sensor
level
Detection of paper end error
Slice
level
15 mm ~
400 mm