3 Loading the Ribbon and Media
45
S84-ex/S86-ex Operator Manual
3.5
Loading Media
Use consumables from our specified suppliers on the product, for optimum print quality.
CAUTION
• The print head and its surroundings are hot after printing. Be careful not to touch it, to avoid being burned.
• Touching the edge of the print head with your bare hand could cause injury.
3.5.1
Loading Label with Dispenser
This section describes the procedure to dispense the label and eject the liner out of the product. The
routing path of the label is shown below. When loading the media, make sure that the print side is facing
up.
1 Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
Label
Platen roller
Pressure
roller
Liner
/DEHO
/LQHU
Feed roller and
media sensor
assembly.
Media shaft
Media shaft
Label
To Next Page
Loading...
