SATO S84 ex - Hex Dump Mode

4 Operation and Configuration
172
S84-ex/S86-ex Operator Manual
4.2.14 Hex Dump Mode
The hex dump mode allows you to print the contents of the receive buffer in a hexadecimal format to
allow the data stream to be examined for errors and troubleshooting.
The flowchart shows the sequence of the setting screens for the hex dump mode. The table describes
each setting screen in detail.
CAUTION
Be sure to perform a virus check on the USB memory or SD card before connecting it to the product. SATO
Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB
memory or SD card.
Hex dump print
RECEIVE BUFFER or
INTERNAL DATA or
SEND BACK DATA
+ button
Shows only if the PASSWORD
input is enabled
Normal print +
Print data save
* Press the , , or button to
select an item or set the value
accordingly. The active arrow icons
are shown on the screen.
Data reception
icon is shown if RECEIVE
DATA is selected.
button
or
button
or
button
button
RECEIVE DATA
+ button
button
button
button
button
Proceed to .
H-A
button
button
PRINT
+ button
button
button
SAVE
+ button
button
Data reception