SATO S84 ex - RFID Printing Tips

9 Appendix
369
S84-ex/S86-ex Operator Manual
9.10.4 RFID Printing Tips
Recommended non-printable zone
Avoid printing barcodes or characters directly on top
of an RFID chip. The uneven surface will negatively
affect the print quality.
Note
The tag offset is adjusted from the base reference point.
The base reference point differs depending on the media
sensor you use. Refer to Section 6.1.1 About the Base
Reference Point for details.
When gap sensor is used, the tag offset is adjusted from
the tip of the label.
When I-mark sensor is used, the tag offset is adjusted
from the position after the I-mark.
15 mm
15 mm
Media feed direction
IC chip
I-mark
Print object
Inlay
Gap
Antenna
RFID
tag/label
Recommended
non-printable zone
Tag
offset
The position for the
best write success
rate on this inlay.