8 Troubleshooting
314
S84-ex/S86-ex Operator Manual
8.4.4
Bad Print Quality
8.4.5
Incorrect Print Position
9 Is the print head defective? Replace the print head and reset the counter.
10 Is the main (CONT) PCB defective? Replace the main (CONT) PCB.
Contact a SATO reseller or technical service
center for replacement.
No. What to check Countermeasure
1 Are the media and ribbon designed for the
product?
Use the media and ribbon designed for the
product.
2 Are the media and ribbon loaded correctly? Check if the media and ribbon are loaded
correctly.
3 Is the tension of the ribbon correct? Adjust the tension of the ribbon.
4 Is the print head installed correctly? Install the print head correctly.
5 Is the pressure of the print head too strong or too
weak?
Adjust the pressure of the print head with the
head pressure adjustment dial.
6 Is the print speed too fast? Adjust the print speed.
7 Is the print darkness too low or too high? Adjust the print darkness.
8 Is the platen roller dirty? If the platen roller is dirty, clean it using the
cleaning kit.
For product cleaning, refer to Section 7.2
Cleaning the Print Head and Platen Roller.
9 Is the print head dirty or is there a label attached
to it?
If the print head is dirty, clean it using the
cleaning pen. If a label is attached to the print
head, remove it.
If the glue of label is attached to the print head,
clean it using a cleaning kit.
Do not clean using a hard object. Doing so could
cause damage to the print head.
For product cleaning, refer to Section 7.2
Cleaning the Print Head and Platen Roller.
10 Is the print head defective? Replace the print head and reset the counter.
11 Is the platen roller damaged? Replace the platen roller.
12 Is the main (CONT) PCB defective? Replace the main (CONT) PCB.
Contact a SATO reseller or technical service
center for replacement.
No. What to check Countermeasure
1 Are the media and ribbon designed for the
product?
Use the media and ribbon designed for the
product.
No. What to check Countermeasure
To Next Page
Loading...
