SATO S84 ex - Adjusting the Head Position

6 Adjusting the Product
281
S84-ex/S86-ex Operator Manual
6.5 Adjusting the Head Position
6.5.1 Left - Right Pressure Balance Setting
Required tool:
Phillips screwdriver
The adjustment procedure for the pressure balance is as follows:
1 Open the top cover of the product.
2 Make sure that the head lock lever is in the lock position.
If it is not locked, turn the head lock lever counterclockwise to lock the print head.
3 Locate the adjust collar  on the side of
the print head assembly.
4 Loosen the screw  attached to the adjust
collar .
Do not remove the screw.
5 Rotate the adjust collar  to adjust the
head pressure balance.
• Rotate the adjust collar counterclockwise to
increase the head pressure on the frame side.
• Rotate the adjust collar clockwise to increase the
head pressure on the opposite side.
Note
If the product orientation is opposite from the photo, the
adjustment direction is reversed.
6 Hold the adjust collar  in the set position
and tighten the screw .
1
2
1