SATO S84 ex - Adjusting the Print Position

6 Adjusting the Product
262
S84-ex/S86-ex Operator Manual
6.1.2 Adjusting the Print Position
Print position is adjustable within the range of +3.75 mm to -3.75 mm (+0.15” to -0.15”) in the adjustment
mode described above. The shift experienced by the media, ribbon or print layout can be offset with the
adjustment of the pitch position.
Note
The above base reference point (print position) will be the stop position when the sensor type is set to Gap
sensor.
Adjust the print position using the following procedure:
1 Make sure that the product is in online mode or offline mode.
2 Press the and buttons for one second
to enter the adjustment mode.
PITCH POSITION shows on the screen.
Adjustment Location Adjustment Range
Adjustment Mode: Pitch Position +3.75 mm to -3.75 mm
(+0.15” to -0.15”)
-3.75 mm (-0.15”) ~ +3.75 mm (+0.15”)
Media feed direction
Print position
(Print head)
Adjustment for
“+” value
No
adjustment
Adjustment for
“-” value
Gap sensor