9 Appendix
353
S84-ex/S86-ex Operator Manual
9.8
Print Speed and Media Size
The minimum media pitch size varies by the print speed setting.
Note
• If using media smaller than the minimum size, the media will not stop at the right position, causing a print
misalignment.
• Do not send the print data with media size that is smaller than the minimum media pitch size, even when the
sensor is disabled.
• The above minimum media pitch sizes are valid only if the print position adjustment and offset adjustment
are set to 0 mm. The minimum media pitch size changes when the print position adjustment and offset
adjustment are set to the value other than 0 mm.
Print speed
(inches/sec)
Continuous mode Dispenser mode
Minimum media pitch
size (mm)
(Thermal transfer)
Minimum media pitch
size (mm)
(Direct thermal)
Minimum media pitch
size (mm)
2 9 13 18
3 9 13 18
4 9 13 18
5111318
6 131318
7 151318
8 171318
9 201318
10 23 13 18
11 27 13 18
12 31 16 18
13 35 20 20
14 40 25 25
15 44 29 29
16 50 35 35
To Next Page
Loading...
