2 Installing the Product
32
S84-ex/S86-ex Operator Manual
2.4
Connecting the Interface Cable
The connection of the interface cable is explained as follows:
2.4.1
Available Interfaces
This product supports the following interfaces.
Furthermore, a product connected with multiple interface cables can continue to operate when receiving
data.
*You cannot receive data from more than one interface at a time.
*You cannot use the USB interface if you have installed the optional wireless LAN.
•USB
•LAN
• RS-232C
• IEEE1284
• Bluetooth
• Wireless LAN (WLAN)
• External signal (EXT)
Note
The wireless LAN interface and Bluetooth interface are optional.
2.4.2
Interface Connections
1 Make sure that the product, host computer and applicator are powered off.
Set the power switch of the product to the “O” position.
2 Connect the product to a host computer with one or more of the available interface
connections.
Use a cable that is compatible with the standard of the interface board as stated in Section 9.12
Interface Specifications. Check the orientation of the connector before you make the connection.
To Next Page
Loading...
