SATO S84 ex - Default Setting Mode

4 Operation and Configuration
193
S84-ex/S86-ex Operator Manual
4.2.18 Default Setting Mode
The product can be reset to the default setting as in the factory preset.
The flowchart shows the sequence of the setting screens for the default setting mode. The table
describes each setting screen in detail.
DEFAULT MODE
Select the item to be initialized.
• PRINTER SETTING: Initialize the settings of the product.
• ALT. PROTOCOL: Initialize the protocol code.
• WLAN SETTING: Initialize the WLAN setting.
Note
WLAN SETTING shows only if a wireless LAN unit is installed.
Select ALT.PROTOCOL
+ button
Press the button
+
Power On
Select PRINTER SETTING
+ button
Select YES
+ button
* Press the , , or button to
select an item accordingly. The
active arrow icons are shown on the
screen.
* WLAN SETTING is available only if a
wireless LAN unit is installed.
Waiting to be powered off.
or
button
Select WLAN SETTING
+ button
Select NO
+ button
button
button
Select YES
+ button
Select YES
+ button