SATO S84 ex - Replacing the Pressure Roller

7 Maintenance
295
S84-ex/S86-ex Operator Manual
7.3.3 Replacing the Pressure Roller
You can easily remove and replace a damaged or worn pressure roller.
1 Make sure that the product is in power off
mode, then disconnect the power cord
from the AC outlet.
2 Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
3 Turn the head lock lever  clockwise to
unlock the print head.
CAUTION
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
4 Push the pressure roller release tab 
up to release the pressure roller plate
.
5 Loosen the screw  until the bearing
clamp  is released.
Do not remove the screw.
6 Remove the bearing  from the chassis
and the shaft of the pressure roller .
7 Pull out the pressure roller  from the
product and replace it with a new
pressure roller.
1
5
6
3
2
4
7