SATO S84 ex - Input;Output Signal of the External Signal

9 Appendix
343
S84-ex/S86-ex Operator Manual
9.5 Input/Output Signal of the External Signal
This section provides additional information about setting the pin number of the input/output signal in the
INPUT SIGNAL/OUTPUT SIGNAL screen of the advanced mode menu.
Setting Conditions
*
1
You cannot select “-” for the PRINT END output signal.
*
2
PRN READY is available only if MODE3 is selected in EXT 9PIN SELECT. The number in
parentheses is the default value when MODE3 is selected.
Note
• When multiple errors are allocated to one pin, the signal is output when one of the errors occurs.
• All errors need to be released in order to switch the signal output back to normal.
• DISPENSE IN and HOME POS. are available only if CONTROLED is selected in BACKFEED MOTION.
Signal Name Input/Output Default Pin No. Overlapping Available Pin No.
PRINT START Input 20 Not Allowed
8, 20
REPRINT Input 8 Not Allowed
LABEL NEAR Input 7 Not Allowed 7, 21, -
Note: When “-” is selected, the
function is disabled.
FEED Input 21 Not Allowed
DISPENSE IN Input 9 Not Allowed
7, 9, 21, -
Note: When “-” is selected, product
operates with PRIN START as a
trigger.
CANCEL Input - Not Allowed 7, 9, 10, 21, 22, -
Note: When “-” is selected, there is
no input.
ON/OFFLINE Input - Not Allowed
PAPER END Output 17 Allowed
4, 5, 6, 16, 17, 18, -
Note: When “-” is selected, there is
no output.
RIBBON END Output 16 Allowed
MACHINE ERR Output 4 Allowed
PRINT END *
1
Output 5 Not Allowed
RIBBON NEAR Output 18 Allowed
HOME POS. Output 3 Not Allowed
3, 4, 5, 6, 16, 17, 18, -
Note: When “-” is selected, there is
no output.
ONLINE Output 6, (19) Allowed
3, 4, 5, 6, 16, 17, 18, 19, -
PRN READY *
2
Output -, (6) Not Allowed