SATO S84 ex - Page 164

4 Operation and Configuration
162
S84-ex/S86-ex Operator Manual
INPUT SIGNAL/OUTPUT SIGNAL
Set the pin number for the input/output signal.
The setting details are as follows:
*
1
PRN READY is available only if MODE3 is selected in EXT 9PIN SELECT. The number in parentheses
is the default value when MODE3 is selected.
Note
• DISPENSE IN and HOME POS. are available only if CONTROLED is selected in BACKFEED MOTION.
• For details, refer to Section 9.5 Input/Output Signal of the External Signal.
Signal Name Input/Output Default Pin No.
PRINT START Input 20
REPRINT Input 8
LABEL NEAR Input 7
FEED Input 21
DISPENSE IN Input 9
CANCEL Input -
ON/OFFLINE Input -
PAPER END Output 17
RIBBON END Output 16
MACHINE ERR Output 4
PRINT END Output 5
ONLINE Output 6, (19)
RIBBON NEAR Output 18
HOME POS. Output 3
PRN READY
*
1
Output -, (6)
212))/,1(3LQ
&$1&(/3LQ
',63(16(,13LQ
3515($'<3LQ
+20(3263LQ